Lighting design, downlight upgrades, power points, ceiling fans, and outdoor lighting installation.
Upgrade outdated fluoros to dimmable LED downlights, add extra power points where you actually need them, install pendant lights over the kitchen island, or run sensor-triggered outdoor lighting around the property. Clean cuts, neat finishes.
Morningside, Carina, Camp Hill, Coorparoo, New Farm, Hawthorne, Bulimba, Norman Park, Cannon Hill — and the wider inner-east Brisbane area for ongoing commercial clients.
Yes — and it's one of the highest-impact upgrades you can do. Modern LEDs use roughly a fifth of the power, run cool, last ten to twenty times longer, and most can be dimmed from a wall plate. We swap the transformers/drivers where needed and tidy up any ceiling damage from the old fittings.
Yes. Whether it's a single double-socket behind the TV or a dozen new outlets through a kitchen renovation, we run new circuits cleanly through wall cavities or ceilings, terminate everything correctly at the switchboard, and patch holes neatly. We'll usually quote per outlet rather than hourly.
Yes. Path lights, deck lighting, sensor-triggered floodlights, pool area lighting and feature lighting on garden walls are all common requests. We use IP-rated fittings designed for Brisbane weather, run wiring through conduit underground where possible, and switch via the existing house circuit or a dedicated controller.
Yes — and it's one of the simpler upgrades. Modern LED-rated dimmers work cleanly with the most common LED downlights and pendant globes. The trick is matching the dimmer to the load type; mismatched dimmers buzz, flicker or kill globes early. We carry the right ones in the van.
We hang anything from a single pendant over a kitchen bench through to multi-arm chandeliers in stairwells. We do the structural anchoring properly (most pendants are heavier than they look), wire to the existing circuit, and adjust the drop height to your specs. Disposal of the old fitting is included.
Yes. If there's an existing light point we wire the fan to a remote-and-light kit or a wall control; if there isn't we run a new switch leg. We balance the blades on install so they run quietly, and we test the timer / reverse / dimmer functions before we leave.
A typical 20-30 downlight retrofit through an average house is one day. Multi-storey homes or homes with sealed insulation take longer. We confirm the timeline in writing before booking.
